Probuilt-professional-lighting Wobblelight Super Duty Bedienungsanleitung PDF herunterladen

Manufactured by ProBuilt Professional Lighting: 877-707-0800

Thank you for purchasing Wobblelight

Super Duty

IMPORTANT SAFETY INSTRUCTIONS

WARNING !!!

READ AND UNDERSTAND ALL INSTRUCTIONS

Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.

SAVE THESE INSTRUCTIONS

This manual contains important safety and operating instructions for Wobblelight

Super Duty portable job site lighting. Before using Wobblelight

Super Duty,

please review all of the following safety instructions carefully and read all labels on the Wobblelight

Super Duty unit.

INSTRUCTIONS PERTAINING TO THE RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE TO UV RADIATION AND INJURY TO PERSONS:

WARNING: To reduce the risk of fire, electric shock, exposure to excessive UV radiation or injury to persons:

 DO NOT connect Wobblelight

to power source until the bulb is installed and the unit is completely assembled.

 Metal halide bulbs get EXTREMELY HOT immediately upon illumination and can cause burns.

 Bulbs stay hot for an extended period of time after Wobblelight

unit has been turned off, and can continue to cause burns.

 DO NOT attempt to remove the protective lens to change bulbs unless the Wobblelight

unit is disconnected from the power source and the bulb has

completely cooled.

 Not for use in wet locations. DO NOT use Wobblelight

where this is potential for exposure to excessive moisture from rain, snow, ice, water spray or

standing water.

 Connect Wobblelight

only to 120 volt, 60 Hz power source which is protected with a ground-fault circuit interrupter (GFCI) and over-current protection

which is rated no higher than 20 amps. Any other connection voids warranty.

 Keep away from flammable materials.

 Wobblelight

must be operated in the upright position only. DO NOT mount Wobblelight

units upside down or restrain them such that they lay on their

side.



DO NOT lift, hoist or suspend Wobblelight

above people or work areas.

 Use only approved extension cords in good condition and of the appropriate type, gauge and length. To connect Wobblelight

units to a power source and

to each other, it is recommended to use 3-wire, 10-gauge extension cords that do not exceed 25 feet in length.

 Keep extensions cords dry and use ground fault circuit interrupter (GCFI) devices in accordance with all applicable electrical code requirements.

1 2 3 4 5 6

Inhaltsverzeichnis

Seite 1 - SAVE THESE INSTRUCTIONS

Manufactured by ProBuilt Professional Lighting: 877-707-0800 Thank you for purchasing Wobblelight® Super Duty IMPORTANT SAFETY INSTRUCTIONS WARNI

Seite 2 - WARNING!

 DO NOT operate Wobblelight® units with the protective dome and cap missing or broken. DO NOT use Wobblelight® units with a broken housing or damag

Seite 3 - Super Duty Wobblelight

 ULTRAVIOLET RADIATION EXPSOURE: WARNING: Metal halide lamps can cause skin burn and eye inflammation from shortwave ultraviolet r

Seite 4

Instructions for Super Duty Wobblelight® assembly: 1. Remove and verify the contents of your Wobblelight® carton. 2. Install the bulb (metal halide

Seite 5

5. Reconnect the Wobblelight® to the power source and turn the power switch on. 6. If the Wobblelight® does not illuminate, turn the unit off, disconn

Seite 6

• Bulbs • Physical damage to plastic components including (but not limited to) domes, caps and housings and inlet / outlet plugs. • Damages or rep

Kommentare zu diesen Handbüchern

Keine Kommentare

Probuilt-professional-lighting Wobblelight Super Duty Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Probuilt-professional-lighting Wobblelight Super Duty herunter. Probuilt Professional Lighting Wobblelight Super Duty User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Beleuchtung Probuilt-professional-lighting Wobblelight Super Duty